Re: [Discuss-gnuradio] [USRP-users] minimum PPS voltage for N200

[mleech]

The PPS input is conditioned with a:

http://www.ti.com/product/SN74AUP1T57/description

Looks to me like it should work just fine.

 

 

 

On 2016-05-03 10:23, khalid.el-darymli via USRP-users wrote:

Hi,

I'll appreciate any help on the following. According to the link below [1], the PPS voltage for N200 should be in the range [3.3, 5] V p-p.
[1] http://files.ettus.com/manual/page_usrp2.html#usrp2_hw_leds

I am getting a PPS signal through fan-outs from an external Firefly-1A GPSDO. I measured the output PPS voltage using a scope, and it is 2.52 V p-p (terminated with 50 ohms).

Would this relatively low PPS voltage work for N200?  I am having a problem syncing two N200 units (2 LFRX/ 1 LFTX ), and I am not sure if this would be the cause?

 

Thank you.

Best wishes,

Khalid

_______________________________________________
USRP-users mailing list
address@hidden
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com