Re: [Discuss-gnuradio] IEEE 802.11 Transceiver Module - Timing offset at receiver side

[Qurat-Ul-Ann Akbar]

I understand. But you didnt connect them directly to the USRP. You used some cable to connect the two and had a stand for your antenna. Can you tell me which cable was that ? 

On Jun 4, 2017 11:13 AM, "Bastian Bloessl" <address@hidden> wrote:

Hi,


On 06/04/2017 04:25 PM, Qurat-Ul-Ann Akbar wrote:

Thank you for the explanation. Can you tell me which antennas did you use for your experiments when you wrote your paper? Because I think a major problem with my receiver is a very low SNR because everything works fine with simulations. Currently I am using Vert 2450 antenna with my USRP N210.

I used the same setup with the Vert 2450 antennas.

Best,
Bastian

On Sun, Jun 4, 2017 at 12:33 PM, Bastian Bloessl <address@hidden <mailto:address@hidden>> wrote:

    Hi,

    On 6/3/2017 9:11 PM, Qurat-Ul-Ann Akbar wrote:

        Hello,

        How is the timing offset being handled in the 802.11 module. I
        see that the sync_long block does frequency offset correction
        and the frame_equalizer block does the phase correction but I
        dont understand where is the timing offset being handled. Can
        anyone tell me which algorithm is being used to do that?


    The Sync Long block correlates the signal with the known pattern of
    the long preamble to derive how the FFTs have to be aligned in time.

    Best,
    Bastian