Hello
I’m wondering if anyone else is having the same trouble with wxgui in Gnuradio.
I’ve installed gnu radio on several MacBooks and ubuntu systems. I’ve got an application we’ve been using for years that uses
wxgui
Now I’ve tried to upgrade to get access to a new SDR but the software is refusing to run as is shown by the same message for gnu radio companion:
File "/Users/glenlangston/Desktop/Research/watch/top_block.py", line 25, in <module> from grc_gnuradio import wxgui as grc_wxgui
Suggestions?
Thanks
Glen
That was it. I overlooked that setting your setup.
Hopefully the last issue. I'm still getting a lot of under flow errors when I use the same radio (A/B ) for a rx and tx block. I have a WBX daughter board in there so simultaneous rx-tx should not be a problem. As mentioned earlier, I was able to get 2rx-tx links running at 5Msps previously with N210s.
Changing the buffer size, file size, or the sampling rate (not the 200e6 one) doesn't help.
Thank you,
AB
From: Michael Carosino <address@hidden> Sent: Monday, November 20, 2017 1:24:17 PM To: Bakshi, Arjun Cc: address@hidden Subject: Re: [Discuss-gnuradio] X310 with 2 WBX in full duplex I've had this error before, can't recall the solution however one thing to try is setting the DDC block select parameters. On the upper DDC block set block select to 0 and on the lower DDC set the block select to 1. (sometimes the auto-select function fails to work correctly I think). _______________________________________________Discuss-gnuradio mailing listaddress@hiddenhttps://lists.gnu.org/mailman/listinfo/discuss-gnuradio
|