I am going through the Getting Started with RFNOC guide and the following command fails
$ ./uhd_image_builder.py window fft -d x310 -t X310_RFNOC_HG -m 5 --fill-with-fifos
I have installed a licensed version of Vivado 2017.4
When I run the above command the output is:
--Using the following blocks to generate image:
* window
* fft
Adding CE instantiation file for 'X310_RFNOC_HG'
changing temporarily working directory to /home/mpnta-rx/rfnoc/src/uhd-fpga/usrp3/tools/scripts/../../top/x300
Setting up a 64-bit FPGA build environment for the USRP-X3x0...
- Vivado: Found (/opt/Xilinx/Vivado/2017.4/bin)
Environment successfully initialized.
make -f Makefile.x300.inc bin NAME=X310_RFNOC_HG ARCH=kintex7 PART_ID=xc7k410t/ffg900/-2 BUILD_1G=1 BUILD_10G=1 SFP0_1GBE=1 SFP1_10GBE=1 RFNOC=1 X310=1 TOP_MODULE=x300 EXTRA_DEFS="BUILD_1G=1 BUILD_10G=1 SFP0_1GBE=1 SFP1_10GBE=1 RFNOC=1 X310=1"
make[1]: Entering directory '/home/mpnta-rx/rfnoc/src/uhd-fpga/usrp3/top/x300'
BUILDER: Checking tools...
* GNU bash, version 4.3.48(1)-release (x86_64-pc-linux-gnu)
* Python 2.7.12
* Vivado v2017.4 (64-bit)
make[1]: *** No rule to make target '/home/mpnta-rx/rfnoc/src/uhd-fpga/usrp3/lib/xge/rtl/verilog/generic_mem_xilinx_block.v', needed by 'bin'. Stop.
make[1]: Leaving directory '/home/mpnta-rx/rfnoc/src/uhd-fpga/usrp3/top/x300'
Makefile:112: recipe for target 'X310_RFNOC_HG' failed
make: *** [X310_RFNOC_HG] Error 2
I have searched my computer for the referenced mission file generic_mem_xilinx_block.v and it is not anywhere on the computer. I assume that it should have been written when I installed Vivavdo.
I am fully stuck here. I need to build a custom image, and next add an OOT FPGA function, but I cant even start until I get past this stage.
John G
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio