Re: [Discuss-gnuradio] [announcement] GNU Radio 3.8 Release Candidate 2

[Barry Duggan]

Thanks Nate.

The two lines I wasn't clear about were:
- git checkout v3.8.0.0-rc2
- git submodule update

Since I already have a clone of rc1, I assume I can just start with 'cd 
gnuradio'. Right?
'git status' says I am up to date with 'origin/master'.

Best wishes,
---
Barry Duggan


On 2019-08-02 09:55, Nate Temple wrote:
> Hi Barry,
>
> You should use git in the command line:
>
> git clone --recursive https://github.com/gnuradio/gnuradio
> cd gnuradio
> git checkout v3.8.0.0-rc2
> git submodule update
> mkdir build
> cd build
> cmake ..
> make
> sudo make install
>
>
> Regards,
> Nate Temple
>
> On Fri, Aug 2, 2019 at 6:41 AM Barry Duggan <address@hidden> wrote:
>
> > I should have put "Re:" on the subject.
> >
> > ---
> > Barry Duggan
> >
> >
> > -------- Original Message --------
> > Subject: [Discuss-gnuradio] [announcement] GNU Radio 3.8 Release
> > Candidate 2
> > Date: 2019-08-02 08:00
> >  From: Barry Duggan <address@hidden>
> > To: Müller, Marcus (CEL) <address@hidden>
> > Cc: Discuss Gnuradio <address@hidden>
> >
> > Hi Marcus,
> >
> > I am planning on upgrading from rc1 to rc2, but (as a git newbie) I
> > don't know how to do it with git. Obviously I could get the source 
> > zip,
> > but that would lose the git tracking functionality.
> >
> > What is the 'proper' way to do it?
> >
> > Best regards,
> > --
> > Barry Duggan
> >
> > On Sat, 20 Jul 2019 22:30:18 +0200, Marcus wrote:
> >
> > You'll find the release on
> >
> > https://github.com/gnuradio/gnuradio/releases/tag/v3.8.0.0-rc2
> >
> > _______________________________________________
> > Discuss-gnuradio mailing list
> > address@hidden
> > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio