|
From: | Dor Ratz |
Subject: | Re: Transmitter and Receiver on the same SDR |
Date: | Wed, 25 May 2022 08:41:37 +0300 |
Thank you for your time Mr. Dor. The problem is gain value. I have been searching for 2 weeks about RF. I will continue to search. Thank you for resolve my problem. Have a nice day.
Gönderen: Dor Ratz <dorratz12@gmail.com>
Gönderildi: 24 Mayıs 2022 Salı 21:53
Kime: Oğuzhan Gedikli <ouzan_ts@hotmail.com>
Bilgi: discuss-gnuradio@gnu.org <discuss-gnuradio@gnu.org>
Konu: Re: Transmitter and Receiver on the same SDRGreat.
Try to send a video of the setup while it is working .
In addition, verify that if there are LED of the connectors they are powered on while working. I don't remember if it should blink or something else.
BestDor
בתאריך יום ג׳, 24 במאי 2022, 9:50 אחה״צ, מאת Oğuzhan Gedikli <ouzan_ts@hotmail.com>:
Thank you for answered.
- I didnt try to raise gain value. I will try tomorrow after this answer.
- I connected 2 antennas. One of them for TX/RX port, I am using this antenna for transmitter. And the other one for RX2 port, using this for receiver. The antennas have same gain.
Gönderen: Dor Ratz <dorratz12@gmail.com>
Gönderildi: 24 Mayıs 2022 Salı 19:12
Kime: Oğuzhan Gedikli <ouzan_ts@hotmail.com>
Bilgi: discuss-gnuradio@gnu.org <discuss-gnuradio@gnu.org>
Konu: Re: Transmitter and Receiver on the same SDRHey,
2 things:
1. Have you tried to raise the gain values in usrp sink and usrp source?
2. Did you connect antenna to each port? Or is it connected with a cable?Post a picture of the setup and it can help.
BestDor
בתאריך יום ג׳, 24 במאי 2022, 3:59 אחה״צ, מאת Oğuzhan Gedikli <ouzan_ts@hotmail.com>:
Hello, I have USRP B200 and i use GNU Radio for design. I want to transmit a random signal (whatever, is'nt important for now) I am using the TX/RX port as transmitter and the RX2 port as receiver. I can transmit signal without any problems but i can't receive it from other port. I am sending screenshots to you. If you are help me, i would be glad. Thank you.
[Prev in Thread] | Current Thread | [Next in Thread] |