Hi,
Thank you for your reply, based on your suggestion I have tried the
following:
①No LO offset set (no uhd.tune_request)
Ch0:Center Freq : freq1
Ch1:Center Freq : freq2
（freq1 = 2.4G, freq2=2.39G,samp_rate=300k）
②Set LO Offset
Ch0:Center Freq : uhd.tune_request(freq1,lo_off1)
Ch1:Center Freq : uhd.tune_request(freq2,lo_off2)
（freq1 = 2.4G, freq2=2.39G, lo_off1=5M, lo_off2=5M,samp_rate=300k）
or （freq1 = 2.4G, freq2=2.396G, lo_off1=2M, lo_off2=2M,samp_rate=300k）
or （freq1 = 2.4G, freq2=2.396G, lo_off1=2M, lo_off2=-2M,samp_rate=300k）
for ①：
In this case, the number of packets received is incorrect and the problem becomes
more serious.
for ②：
In this case the BER is still very high (I don't think it's my system because the
transmit power is set to 1 (Normalized) and the BER is quite low when using one RF
channel, but I still think I'm using the USRPB210's dual channel transmission mode
incorrectly)
Best Regards！
------------------ 原始邮件 ------------------
*发件人:* "Marcus Müller" <marcus.mueller@ettus.com>;
*发送时间:* 2022年12月6日(星期二) 晚上8:49
*收件人:* "discuss-gnuradio"<discuss-gnuradio@gnu.org>;
*主题:* Re: Problems implementing USRP b210 dual channel transceiver
There's only one physical TX LO; so either you just don't specify offsets, OR
they must
add up to the difference between the two target frequencies.
In your case, the difference is 10 MHz, but your offsets don't add up to 10
MHz, and
you're requesting something impossible.
Best regards,
Marcus
On 06.12.22 12:45, 能书能言 wrote:
> Hi,
> I am using OFDM + USRPB210 for data transmission. I am using two
USRPB210s, one being
> used as a transmitter and the other as a receiver. When I use only one of
the channels
> (RFA or RFB) the data can be transmitted properly. I needed to transmit two
different data
> at the same time, so I used both the USRP RFA and RFB. the baseband
processing part of the
> link was the same for both channels (including channel coding, modulation,
FFT, etc.), but
> at this point I found that I was transmitting data with a very high BER (for
both links).
> again, mentioning that there was no problem when sending on one channel
alone, I The USRP
> Sink and Source settings are shown in the attached picture.
> where
> freq1=2.4G
> freq2=2.39G
> lo_off1=2M
> lo_off2=-2M
> samp_rate=300K
> The two signals are separated using different frequencies, I don't think
there should
> be any interference between them, and I have troubleshot errors other than
USRP source and
> sink, so I think there is something wrong with my parameter settings, or I
am using the
> two RF channels in an incorrect way. How should I modify this?Looking
forward to your
> response！
>
> Best Regards!
>