RE: projectcenter launch error Windows10

[James d'Authreau]

I uninstalled everything and reinstalled them. Same problem.  I compared the 
windows 7 and 10 installations, all the dll's seemed to be there.  Crucially 
the folder gnustep in c:\users\myusername\gnustep   was not there on the 
windows 10 version. In the vain hope that a copy and paste job would work I 
tried this, but sadly not. I tried the new installer, but again no folder is 
created. Just a thought the windows 7 was 64bit  and windows 10 is 32bit. Is 
the installer for projectcenter etc only 64 bit?
James   

-----Original Message-----
From: Germán A. Arias [mailto:germanandre@gmx.es] 
Sent: 20 November 2015 18:04
To: James dAuthreau
Cc: Riccardo Mottola; <discuss-gnustep@gnu.org>
Subject: Re: projectcenter launch error Windows10

Hi,

El vie, 20-11-2015 a las 16:47 +0000, James dAuthreau escribió:
> Hi Riccardo
> 
> Following my last post I installed GNUstep on a windows 7 machine, and 
> it works fine, so it rather points to a Windows 10 issue, so it would 
> be great if an installer that works for Windows 10 could be developed, 
> as most people will / have upgraded to this at some point.
> 
> James

Remove all and try again, maybe it was an error at installation. If not works, 
try with this:

https://www.dropbox.com/s/mb4m65spkuf3o0f/GNUstep-1.0.exe?dl=0

This is a more recent installer with SystemPreferences, Gorm and Gemas.
But I haven't tested it on Windows 10, and don't contains ProjectCenter.
So if works, you will need install it from source.

Germán