Re: Export LaTeX command inside figure environment

[Juan Manuel Macías]

Hi, Thomas,

Thomas S. Dye writes:

> Is there a way to add an arbitrary LaTeX command between
> \begin{figure} ... \end{figure} during LaTeX export?  I want to end up
> with the following snippet, but can't figure out how to slip in
> \setfloatalignment{b}.  \begin{figure}[htb]
> \centering
> \includegraphics[width=.9\linewidth]{hilbertcurves.pdf}
> \caption[Hilbert curves]{\label{fig:orgparagraph1} Hilbert curves of
> various degrees \emph{n}.}
> \setfloatalignment{b}
> \end{figure}

I think the :caption attribute could do the trick (of course everything
must be on one line):

#+ATTR_LaTeX: :caption \caption[Hilbert
 curves]{\label{fig:orgparagraph1} Hilbert curves of various degrees
 \emph{n}.}\setfloatalignment{b}

Best regards,

Juan Manuel