Re: Herd works with network not at all

[znavko]

You know, after I increased delay after services were stopped 
to 8 seconds
and also placed dealy 8 seconds between start of wpa-supplicant and start of 
networking
My reconnections are working nice.
I think the reason is the delay, but it is just practical knowledge, not 
academical...


December 20, 2020 9:38 PM, "znavko--- via" <help-guix@gnu.org> wrote:

> Hello, Guix! My simple script is just using for reconnect to Internet 
> provider from those 2 I use.
> 
> It works bad.
> I have internet after PC was booted.
> And then I have to use this script to connect to another provider (just for 
> to change IP).
> I run my script with `# ./wpa bee` and it does things but I have no Internet 
> and ping does not find
> host gnu.org
> 
> This script stops two services in my system
> networking
> wpa-supplicant
> And then runs them with new wpa-supplicant config.
> 
> I placed `sleep 2` there between stopping and running services. But did not 
> get it works fine.
> 
> My new config and using of another Internet provider works after reboot.
> Also it works without herd just with
> 
> # wpa_supplicant -B -i wlp2s0 -c /etc/wpa_supplicant/wpa_supplicant.conf
> # dhclient -v
> 
> I cannot see errors in herd services. Herd services works badly, but hand 
> made connection works
> fine.
> Is the deal over 2 seconds of delay? Do I need to increase delay period?
> 
> Please, what do I need to consider?