[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Thu, 17 Jan 2002 12:55:40 -0800
I have successfully installed Hurd H2. I am interested in joing the Hurd
development effort. In the interim, I'd like to configure networking. Hurd
recognizes my Intel EtherExpress Pro. A driver is apparently loaded,
expecting to service eth0.
However, I'm not sure how to go about configuring eth0. Can someone give me
the steps to setup eth0 and configure networking in this environment?
- Configuring Networking,
Errno Mach <=