Re: Which engraver creates \fermataMarkup

[Mats Bengtsson]

See section "Multi measure rests" in the manual.

   /Mats

Reinhold Kainhofer wrote:
> I'm having a piece with each vocal voice split into two, which are printed on 
> the same staff. As I only want to print dynamics, articulations etc. once, I 
> simply remove the corresponding engravers from the second voice. However, I 
> have not been able to find the proper engraver for the \fermataMarkup.
>
> Attached is an example, where I have successfully removed the \p, the \accent, 
> an ordinary _"Text" and a normal \fermata from the second voice, but the 
> \fermataMarkup is apparently not created by either Dynamic_engraver, 
> Text_engraver, Script_engraver or Mark_engraver...
>
> So, the question is, which engraver does create the fermata on whole rests?
>
> Thanks,
> Reinhold
>
>   
> ------------------------------------------------------------------------
>
> _______________________________________________
> lilypond-user mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/lilypond-user

--
=============================================
        Mats Bengtsson
        Signal Processing
        Signals, Sensors and Systems
        Royal Institute of Technology
        SE-100 44  STOCKHOLM
        Sweden
        Phone: (+46) 8 790 8463                         
       Fax:   (+46) 8 790 7260
        Email: address@hidden
        WWW: http://www.s3.kth.se/~mabe
=============================================