Re: [Ltib] How to include kernel headers (phy3250)?

[Lukasz Gesieniec]

Hi Stuart,

I can't see this option. My screen looks like this:

                 --- Choose your Kernel
                     kernel (Linux 2.6.27.8 for LPC3250/Phytec 3250)  --->
                 [*] Always rebuild the kernel
                 [ ] Produce cscope index
                  (linux-2.6.27.8-phy3250.config) Kernel preconfig
                  [*] Configure the kernel
                  --- Leave the kernel sources after building
                  --- Package selection
Regards,
Lukasz


Dnia 14-04-2010 o 10:16:24 Stuart Hughes <address@hidden> napisał(a):

> Hi Lukasz,
>
> Run ./ltib -m config and enable the option "Include kernel headers" and
> then run ./ltib.  It's on them opening page just after the kernel config
> file option. I don't have that BSP configured, but the one I have looks
> like this:
>
> ...
> (mpc834x_itxgp_defconfig) kernel config file
> [*] Include kernel headers
> [ ] Configure the kernel
> ....
>
> Regards, Stuart
>
> Lukasz Gesieniec wrote:
> > Hello,
> >
> > I'm working with LTIB and phy3250 board. I do not see the option to
> > Include kernel headers.
> > Compiling DirectFB causes the following error:
> >
> >
> > + [ ! -f
> > /home/lukaszge/ltib/rootfs/usr/src/linux/include/linux/autoconf.h ]
> > + cat
> >
> > No file:  
> > /home/lukaszge/ltib/rootfs/usr/src/linux/include/linux/autoconf.h
> >
> > You need to build the kernel and have 'Include kernel headers' set
> > to build this package
> >
> > + exit 1
> > error: Bad exit status from /home/lukaszge/ltib/tmp/rpm-tmp.47635  
> > (%build)
> >
> >
> > RPM build errors:
> >     Bad exit status from /home/lukaszge/ltib/tmp/rpm-tmp.47635 (%build)
> > Build time for DirectFB: 0 seconds
> >
> > Failed building DirectFB
> >
> > Regards,
> > Lukasz


--
Używam klienta poczty Opera Mail: http://www.opera.com/mail/