Hi Jorge,
Make sure that /sbin/ip is actually from iproute2 and not the busybox
version.
Also check your syntax, I'm not sure if that's correct. You can check
the LTIB iproute2 man page by looking at the rootfs NFS area:
nroff -man rootfs/usr/share/man/man8/ip.8 | less
Regards, Stuart
Jorge A. Castro wrote:
Hi everyone in the mailing list. I'm using the iproute because I need to
create a netdevice to use with the Virtual CAN. I enabled the iproute
for compilation, result was ok, but when using it I can't do
ip link add type *vcan*
I got that command "add" is unknown. Typing ip link help I had:
Usage: ip link set DEVICE { up | down |
arp { on | off } |
dynamic { on | off } |
multicast { on | off } |
allmulticast { on | off } |
promisc { on | off } |
trailers { on | off } |
txqueuelen PACKETS |
name NEWNAME |
address LLADDR | broadcast LLADDR |
mtu MTU }
ip link show [ DEVICE ]
and it seems that the "add" option is not available. How can I have it?
Looking at my host iproute application it brings me a lot of more
options rather than the one in LTIB.
Any help on this?
Best regards!
--
Jorge A. Castro
Canam-Technology, Inc.
------------------------------------------------------------------------
_______________________________________________
LTIB home page: http://ltib.org
Ltib mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/ltib