Hello,
I’m running ltib on lpc 3250 board, and on boot, the
process gets stuck after the linux kernel has been read from USB flash drive.
Any ideas on how to proceed?
Thanks,
Nish
Kickstart bootloader started...
Detected NAND Flash ID is: f1ec
Kickstart: reading application data
Kickstart: starting application
Embedded Artists LPC3250 board
Build date: Nov 28 2009 16:10:47
Autoboot in progress, press any key to stop
U-Boot 2009.03-rc1 (Sep 07 2010 - 12:05:35)
DRAM: 64 MB
NAND: 128 MiB
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
(Re)start USB...
USB:
ISP1301 Vendor ID : 0x04cc
ISP1301 Product ID : 0x1301
ISP1301 Version ID : 0x0210
scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage
Device(s) found
reading uImage
................................................................................
..........................................................................
1584624 bytes read
stopping USB..
## Booting kernel from Legacy Image at 80100000 ...
Image Name: Linux-2.6.27.8
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1584560 Bytes = 1.5 MB
Load Address: 80008000
Entry Point: 80008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing
Linux.............................................................
...................... done, booting the kernel.