Hello Everyone,
I'm using a Texas Instruments RM57L843 microcontroller and I would
like to communicate with it from the PC. I managed to set up
communication with static IP, and successfully pinged the controller.
I'm using the drivers provided by TI. I'm using raw api, trying to
keep things as low level as possible.
Now I would like to extract data from the bitstream, e.g.: if I press
"P" on the keyboard of the computer, I would like to extract that "P"
in the controller from the bitstream; and this applies to not just
letters, but words and numbers, too.
Also, I noticed that there were significantly more packets received by
the controller, than the 4 ping packets - I guess, these were part of
the necessary network communication. So another job would be to
extract the packets I need, I send, from this dataflow.
Thanks for your reply in advance.