[Octave-bug-tracker] [bug #50479] build fails on osmesa print

[Michael Godfrey]

Follow-up Comment #26, bug #50479 (project octave):

My previous entry is not quite accurate. I just did
a clean build and the failure due to osmesa version has
returned as Dmitri reported. For the build to complete
I had to do: make -i and no documentation was generated
in doc/interpreter.

But, if I run:
./run-octave --no-gui 
randn("state",1);
hist(randn (10000,1),30)
graphics_toolkit
ans = fltk
========================
I get a correct histogram as I did with the previous system.
And, as before print xxhist.pdf produces the diagonal lines.
So, now I have no explanation of how my build system 
started to complete using gnuplot.



    _______________________________________________________

Reply to this item at:

  <http://savannah.gnu.org/bugs/?50479>

_______________________________________________
  Message sent via/by Savannah
  http://savannah.gnu.org/