[Octave-bug-tracker] [bug #61835] GNU Octave GUI runs with 4.4.1 (w32), 5.2.0 (w32) and 6.1.0 (w32) but not with 6.3.0, 6.4.0 (w32) under windows 10.

[halit]

Follow-up Comment #12, bug #61835 (project octave):


[comment #11 comment #11:]
> [comment #10 comment #10:]
> > We are getting slowly there.  Thus, it is possible to start the Octave
6.3.0 and 6.4.0 CLI (command-line interface = black terminal) versions of
Octave on your system.  This is a very important information if Octave
entirely refuses to work or the GUI is just not showing up for an unknown
reason 😉
> > 
> > When you start Octave 6.4.0 CLI, can you run commands like
> > 
> > 
> > plot (1:10)
> > 
> 
> I have just downloaded and installed 6.4.0 using
"octave-6.1.0-w32-installer"
> Installation run ok, no errors. It is installed under this directory:
> C:\Octave\Octave-6.4.0
> 
> I started up CLI and ran "plot(1:10)" a window popped up and a graphic
showed up without any problem. I exited CLI. Then I invoked GUI, it showed up
for a couple of seconds and then shut down before I did anything... that is
all.
> 
> On my notebook, the other three releases (4.4.1, 5.2.0 and 6.1.0) run OK
(both CLI and GUI) without any problem... 
> 

I just did a typo error above, and the actual installer I used is as follows:
"octave-6.4.0-w32-installer.exe"


    _______________________________________________________

Reply to this item at:

  <https://savannah.gnu.org/bugs/?61835>

_______________________________________________
  Message sent via Savannah
  https://savannah.gnu.org/