[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Paparazzi-devel] RE: using make command to create gerber files

From: David Conger
Subject: [Paparazzi-devel] RE: using make command to create gerber files
Date: Fri, 30 Nov 2007 16:09:52 -0800


I really made a mess of that message below. 

I meant to say simply doesn't the "make" command from paparazzi3/hw/ directory work to create the 4 layer boards correctly? 

I read directions how on the Wiki. Before I waste money using those gerbers to build boards I was hoping someone could confirm that info on the Wiki is accurate. I thank Uttam for posting those steps but are they necessary if "make" will do the same thing?

Best Regards,

On Nov 30, 2007, at 9:00 AM, address@hidden wrote:

Message: 2
Date: Thu, 29 Nov 2007 15:16:58 -0800
From: David Conger <address@hidden>
Subject: [Paparazzi-devel] Re: Paparazzi Tiny13 help
To: address@hidden
Message-ID: <address@hidden>
Content-Type: text/plain; charset=US-ASCII; delsp=yes; format=flowed


Can anyone comment on running the "make command" from /paparazzi3/hw ?

That generates "gerber" files ... can someone run it and confirm it  
did create a 4-layer gerber set?

I can run the command, it generates the files, but I'm not sure what  
I'm looking at .. I do admit I lack a Gerber viewer.

For someone who knows what to look for it should be an easy matter to  
check the gerber files created. If they are correct then why not  
simply generate them using the "make gerber" command in the "hw"  


reply via email to

[Prev in Thread] Current Thread [Next in Thread]