paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Tiny13 1.1 / Servo Output


From: Matthew Currie
Subject: Re: [Paparazzi-devel] Tiny13 1.1 / Servo Output
Date: Mon, 28 Jan 2008 19:10:36 -0800
User-agent: Thunderbird 2.0.0.9 (Windows/20071031)

Group,


Well it looks like I did cross some code. I found reference to 4017 servo code and changed it to 4015_MAT. Manual mode now works.


Regards,
Matthew

Matthew Currie wrote:
Group,


I have been diagnosing my servo output problem on my Tiny13 1.1 for some time now. I put the Tiny13 under a 20-400x digital microscope and verified that all the crucial solder joints are great. I currently have the Tiny13 under a DSO and now see that SERV_CLK is sending what looks like a reasonable clock, the SERV_RESET is sending a signal, but the SERV_DATA line is being held at VCC with no PPM signal present. This now explains why my servos were moving to extremes and binding the control surfaces. I checked the SERV_DATA line all the way to the LPC pin and verified it is held high there. Is there something obvious I am missing? Is this a symptom of a software misconfiguration? Did anything change between Tiny13 and Tiny2 and maybe I have a bit of code crossed over? Thanks guys.


Regards,
Matthew


_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel





reply via email to

[Prev in Thread] Current Thread [Next in Thread]