|
| From: | 郭 flying pig |
| Subject: | RE: [Paparazzi-devel] 3 state switch on any R/C controller |
| Date: | Sat, 30 May 2009 18:24:01 +0000 |
|
Hi there I did that, and the results i get is like on/off only, it is strange. I also try this experiment on the Futaba Skysport 4, some how it gives 3 state, but the neutral react very slow, and when i put it in paparazzi, it tend to shut of the rc link. Thanks anyway Chen > From: address@hidden > To: address@hidden > Subject: Re: [Paparazzi-devel] 3 state switch on any R/C controller > Date: Sat, 30 May 2009 21:08:07 +0400 > > Hello > try to add two resistor divider between switch inputs. this would give central position. > > 30.05.09, 17:04, "? flying pig" <address@hidden>: > > > Hi there > > > > I have recently got one of the remote controll from someone, it is 4 channel 40Mhz, the brand is REELY (from Conrad in Germany i believe). I was thinking using for paparazzi. > > > > I have tap in to the R/C receiver, which was ok (just read the chip number without any measurement), however, I have some didfficulty in making 3 state switch. > > > > > > I cut the yaw channel (4th channel), and rewire to 3 state switch (on/off/on), however, when i use it, it seen like only have on/off function. > > > > > > Does anyone has done the similar thing about cutting one channel from the controller to make it into the 3 state switch? can anyone advice? > > > > > > > > Regards > > > > Chen > > 5 GB ???? ????????????????? ― ???? Windows Live Hotmail > -- > Есть ли письма? Знает мобильная Яндекс.Почта http://mobile.yandex.ru/online > > > _______________________________________________ > Paparazzi-devel mailing list > address@hidden > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel 5 GB 超大容量 、��新便捷、安全防�o垃圾�]件和病毒 ― 立即升�� Windows Live Hotmail |
| [Prev in Thread] | Current Thread | [Next in Thread] |