[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Reply to "Can't get XBee's to work " (chris) #2

From: Gautier Hattenberger
Subject: Re: [Paparazzi-devel] Reply to "Can't get XBee's to work " (chris) #2
Date: Thu, 20 Aug 2009 10:31:55 +0200

Hello Maik,

If you are using the serial mode, the XBEE_INIT and NO_XBEE_API_INIT won't change anything and the DATALINK section is not even needed (default mode) so you can remove it.
If the TWOG sends messages at the right speed (you can check that with an oscilloscope), then the problem can come from the parameters of the link agent. What is the speed of your ground modem ? What are the parameters of link ?


2009/8/19 Maik Höpfel <address@hidden>

Well, I only get garbled characters when listening in to TWOG to PC, not when trying out communication between the modems. If I'm not mistaken, PPRZ uses a binary protocol, so getting garbled chars doesn't say much, right? But thanks, I'll give it a try and will also try disabling my wifi.

19. Aug 2009 7:09 nachm. schrieb am "chris" <address@hidden>:

I forgot to mention that if you get garbled characters then try to change the 2.4 Ghz channel.
Default is the "C" channel.
I had to do it also (i went to "D") as it was messing with my Wifi.

Paparazzi-devel mailing list

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]