[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Booz PCBs from Eurocircuits

From: antoine drouin
Subject: Re: [Paparazzi-devel] Booz PCBs from Eurocircuits
Date: Wed, 5 May 2010 23:12:03 +0200

mmmm  and I forgot to mention : the bunch of uarts on Lisa which
allows to use a spektrum 2.4Ghz rc receiver at the same time as a GPS
and a radio modem

On Wed, May 5, 2010 at 11:08 PM, antoine drouin <address@hidden> wrote:
> Hello Marko
> the Makefile in the hw directory handles CAM generation by passing
> command line arguments to eagle. It uses the design rules file in the
> hw/fab directory
> I use the verified/4L service from eurocircuits, and there is a set of
> rule for it. You might want to create another set of rules if you
> intend to use another service.
> Now..... you might be able to get ready made Booz PCBs from one of the
> two Davids
> Also... unless you're in an extreme hurry, I think you should take a
> look at Lisa/L ( ) which is a far
> more capable plateforme than Booz (I love JTAG and being able to ssh
> on my quad and would never go back now )
> Lisa/L boards are being manufactured at the time being and should be
> available in a couple of weeks. Booz IMU is compatible with Lisa/L
> There is also a new revision of the IMU in the pipe, which should be
> more affordable than the current Booz IMU
> Regards
> Poine
> On Wed, May 5, 2010 at 6:10 PM, Marko Thaler <address@hidden> wrote:
>> Hello everybody,
>> I decided to make my own Booz hardware using Eurocircuits PCB service. I
>> have generated the panel using makefile in hw/booz/panel directory, checked
>> the gerbers and everything seemed fine. However, at Eurocircuits the files
>> have been rejected. The reason is the Outer Annular Ring (OAR) in their
>> Standard Pooling Service is 0.125mm, but the Booz PCBs have OAR of 0.0944mm.
>> In order to modify the PCBs I need the Eagle CAM Processor Job file (.cam)
>> for CAM data generation. I have not found any .cam files in the paparazzi
>> repository. Do I use one of the "built in" Eagle .cam files and if so which
>> one?
>> Thank you for your help!
>> Kind regards,
>> Marko Thaler
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]