[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] XBEE PRO ZB

From: Eric Parsonage
Subject: Re: [Paparazzi-devel] XBEE PRO ZB
Date: Sun, 9 May 2010 11:29:41 +0930

Hi Antoine

I have found that I can only program the xbee with hardware handshaking 
enabled. But the booz board doesn't use hardware handshaking. (it only suplies 
power and rx/tx) so I am thinking I need to change the D7-DI07 D6-D6-DI06 
settings on the xbee using X-CTU.

 Currently D7-DI07 is set to 1 (CTS FLOW CONTROL) and  D6-D6-DI06 is set to 0 
(DISABLE) can you let me know what these settings should be ?



On 09/05/2010, at 11:17 AM, antoine drouin wrote:

> Hi Eric
> The only thing I change on my xbees is the baudrate - I think they
> come configured at 9.6k and I switch them to 57.6k
> Seeya
> Poine
> On Sun, May 9, 2010 at 2:55 AM, Eric Parsonage <address@hidden> wrote:
>> Hi All,
>> My first time using XBEEs as telemetry link. Can anybody give me some 
>> instructions on what to set in their configuration ?
>> BTW this is for a booz board.
>> Regards
>> Eric Parsonage (Snr)
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]