[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

AW: [Paparazzi-devel] GCS problem

From: Roman Nikitin
Subject: AW: [Paparazzi-devel] GCS problem
Date: Thu, 8 Jul 2010 17:53:47 +0100

Thank you for advise,  I will try to do it for the next OS installation.


Von: address@hidden [mailto:address@hidden Im Auftrag von Adam Spence
Gesendet: Donnerstag, 8. Juli 2010 17:32
An: address@hidden
Betreff: Re: [Paparazzi-devel] GCS problem


Hey Roman,

I have Ubuntu, XP and Win7 on mine. I think you might find that Ubuntu doesn't like your hardware. I would suggest installing VirtualBox in Win7 and running Paparazzi in there. It's a clean abstraction layer which works with Paparazzi and Ubuntu.

Good luck

On 8 July 2010 11:07, Roman Nikitin <address@hidden> wrote:



I tried really everything. What I could find is that I need to push the button Execute several times until the GCS is started properly. I get also sometimes a couple of the messages from OS (Ubuntu) about some kernel problems. I think that is why I have such problems. I have two OS on the laptop, Linux and WIN7.


Now, I know where the problem is. I will try to reinstall my OS, and will use jut one OS on one hard drive. I found in some forums that Linux and WIN don´t like each other. That is why sometimes some kernel errors appear.







Von: [] Im Auftrag von Maik Höpfel
Gesendet: Donnerstag, 8. Juli 2010 16:17
An: address@hidden
Betreff: Re: [Paparazzi-devel] GCS problem


Hey Roman,
There's definitely something at fault there. Both of our Paparazzi boards and components have proven very reliable. Check your power source and all connections. Pipe a short textfile over the Xbees to check for transmission errors. It should come out the same on both ends, you might use md5sum to check automatically. The Xbees do error checking, so there shouldn't be any difference, really.
Other than that, debug, try, eliminate possible sources of error one by one...

Good luck!
- maik

Am 08.07.2010 16:51 schrieb "Roman Nikitin" <address@hidden>:

After I tried to start the GCS 6-7 times it is working now. But I don´t  see why it happens. And I am still looking for the ideas.




Bristol Institute of Technology

University of the West of England

Aerospace Systems Engineering

email: address@hidden

Mob.: +44 (0) 7760806643


Paparazzi-devel mailing list

Paparazzi-devel mailing list


reply via email to

[Prev in Thread] Current Thread [Next in Thread]