|
From: | Roman Nikitin |
Subject: | [Paparazzi-devel] IR sensors and loop definition |
Date: | Tue, 13 Jul 2010 16:58:04 +0100 |
Hey everyone, on the wiki page I did read about vertical
and horizontal controls. I found the expressions like “vertical/horizontal
conrol loops”, “low level control loops” , “main loop”.
What do these expressions mean? I know what is the loop, but what is
about these particular terms? In the time was checking if my IRs
works correct, I detected that if I place the model in approx. 45 roll
position angle, the PDE gage in GSC shows me approx. 20 degrees and responds
to slow. Could I influence such behaviours changing some parameters in IR sensor
section in airframe file? How can I correct these errors? Regards, Roman Bristol Institute of Technology University of the West of England Aerospace Systems Engineering email: address@hidden Mob.: +44 (0) 7760806643 P please
consider the environment before printing this email.
|
[Prev in Thread] | Current Thread | [Next in Thread] |