|
From: | Edixon Giraldo |
Subject: | RE: [Paparazzi-devel] Xbee pro modules won't communicate |
Date: | Mon, 9 Aug 2010 11:44:27 -0500 |
I am sorry for my ignorance, but, how do you do that? I am not familiar with the XCTU configuration software. Thanks. Eddie. > Date: Mon, 9 Aug 2010 18:14:23 +0200 > From: address@hidden > Subject: Re: [Paparazzi-devel] Xbee pro modules won't communicate > To: address@hidden > > Hi, > > you have to "bind" the modules if you want to use the transparent mode (what is suggested for the first trials..) > So go to CTU and set the number of the other module as destination adress. The same for the other module respectively. > > Then they act just like a serial cable. > > Marc > > -------- Original-Nachricht -------- > > Datum: Mon, 9 Aug 2010 10:37:31 -0500 > > Von: Edixon Giraldo <address@hidden> > > An: "address@hidden" <address@hidden> > > Betreff: Re: [Paparazzi-devel] Xbee pro modules won\'t communicate > > > No, I have not touched the firmware. I have no idea what is wrong then. > > Thanks. > > > > Sent from my iPhone > > > > On Aug 9, 2010, at 10:29 AM, Felix Ruess <address@hidden> wrote: > > > > > then it should work out of the box... no coordinator needed. > > > unless you already flashed a different firmware. > > > > > > On Mon, Aug 9, 2010 at 5:11 PM, Edixon Giraldo <address@hidden> > > wrote: > > >> I have the xbee pro 802.15.4 > > >> > > >> Sent from my iPhone > > >> > > >> On Aug 9, 2010, at 9:59 AM, Felix Ruess <address@hidden> wrote: > > >> > > >>> Hi, > > >>> > > >>> the configuration (coordinator needed or not) you need depends on > > >>> which version exactly you have. > > >>> > > >>> Basically two different hardware/software stacks: > > >>> Digi XBee Pro 802.15.4 and Digi XBee Pro ZB > > >>> > > >>> See http://paparazzi.enac.fr/wiki/Modems for that also > > >>> > > >>> Cheers, Felix > > >>> > > >>> On Mon, Aug 9, 2010 at 4:43 PM, maq <address@hidden> wrote: > > >>>> Did you already check out this guide? I used it successfully a few > > weeks > > >>>> ago. > > >>>> > > >>>> http://pixhawk.ethz.ch/tutorials/how_to_configure_xbee > > >>>> > > >>>> > > >>>> Am 09.08.2010 um 16:28 schrieb Edixon Giraldo: > > >>>> > > >>>>> Hi, I have been working with this for hours and cannot make the xbee > > >>>>> modules to communicate with each other. I am very new at this, > > therefore, I > > >>>>> am not very familiar on bow to set them up to make one the > > coordinator and > > >>>>> the other one the server. Any ideas on how to do this in XTCU? I did > > find > > >>>>> some instructions on how to do this, but, it was not clear to me. It > > seems > > >>>>> that you have to type some commands on a terminal. I have also been > > trying > > >>>>> to run range tests and all, but, it is not successful. > > >>>>> Any help will be greatly appreciated. > > >>>>> > > >>>>> Thanks. > > >>>>> > > >>>>> Eddie. > > >>>>> > > >>>>> Sent from my iPhone > > >>>>> _______________________________________________ > > >>>>> Paparazzi-devel mailing list > > >>>>> address@hidden > > >>>>> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel > > >>>> > > >>>> > > >>>> _______________________________________________ > > >>>> Paparazzi-devel mailing list > > >>>> address@hidden > > >>>> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel > > >>>> > > >>> > > >>> _______________________________________________ > > >>> Paparazzi-devel mailing list > > >>> address@hidden > > >>> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel > > >>> > > >> > > >> _______________________________________________ > > >> Paparazzi-devel mailing list > > >> address@hidden > > >> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel > > >> > > > > > > _______________________________________________ > > > Paparazzi-devel mailing list > > > address@hidden > > > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel > > > > > > > _______________________________________________ > > Paparazzi-devel mailing list > > address@hidden > > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel > > -- > Neu: GMX De-Mail - Einfach wie E-Mail, sicher wie ein Brief! > Jetzt De-Mail-Adresse reservieren: http://portal.gmx.net/de/go/demail > > _______________________________________________ > Paparazzi-devel mailing list > address@hidden > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel |
[Prev in Thread] | Current Thread | [Next in Thread] |