[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Paparazzi-devel] Sensors correcting control surfaces in the wrong direc
From: |
Edixon Giraldo |
Subject: |
[Paparazzi-devel] Sensors correcting control surfaces in the wrong direction |
Date: |
Sun, 15 Aug 2010 00:51:27 -0500 |
Hi, I need some help figuring out this issue. I am so close to finishing my
project, but, yet so far. I have calibrated the sensors and positioning them in
the correct orientation in the airframe. They match the PFD in the GCS and move
in the correct direction. However, the autopilot does not correct the control
surfaces of the airframe in the correct direction. When nose up, it corrects
the roll. When it rolls it corrects the pitch. In other words it is switched.
In manual mode I have correct control of the aircraft, but, in automatic, the
pitch and roll corrections are opposite. I have checked the correct orientation
of the sensors by following the tuning procedures in the wiki. Positive for
bottom, right and back. Ir1 from wingtip to wingtip, and Ir2 from nose to tail.
I don't know what else to adjust. Any ideas on how to correct this?
Thanks.
Eddie.
Sent from my iPhone
- [Paparazzi-devel] Sensors correcting control surfaces in the wrong direction,
Edixon Giraldo <=