Re: [Paparazzi-devel] EagleTree Airspeed Sensor codes

[Felix Ruess]

You actually should get an error message telling you to change it to
twog_1.0 if you still have twog_1 set as your board.

On Fri, Nov 5, 2010 at 4:52 PM, Martin Mueller <address@hidden> wrote:
>
> try twog_1.0 instead of twog_1
>
> On 05.11.2010 16:41, Roman Nikitin wrote:
>>
>> Hi all,
>>
>> I used the instructions on wiki to add the codes for EagleTree Airspeed
>> Sensor. Before I did it, my simulation was running unobstructed. After I
>> did add the codes I have a number of errors.
>>
>> As I did error check, I realised that most of the .xml documents do not
>> exist anymore.
>>
>> Please could anybody check the instructions on the wiki, if they are
>> up-to-date. And it would be quite useful to have an example code so that
>> I can compare my and working codes.
>>
>> I am using Twog1.
>>
>> Thank you.
>>
>> Regards,
>>
>> Roman
>>
>> Bristol Institute of Technology
>>
>> University of the West of England
>>
>> Aerospace Systems Engineering
>>
>> email: address@hidden <mailto:address@hidden>
>>
>> Mob.: +44 (0) 7760806643
>>
>> *P** **please consider the environment before printing emails.** *
>>
>>
>>
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden
>> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>