You actually should get an error message telling you to change it to
twog_1.0 if you still have twog_1 set as your board.
On Fri, Nov 5, 2010 at 4:52 PM, Martin Mueller<address@hidden> wrote:
try twog_1.0 instead of twog_1
On 05.11.2010 16:41, Roman Nikitin wrote:
Hi all,
I used the instructions on wiki to add the codes for EagleTree Airspeed
Sensor. Before I did it, my simulation was running unobstructed. After I
did add the codes I have a number of errors.
As I did error check, I realised that most of the .xml documents do not
exist anymore.
Please could anybody check the instructions on the wiki, if they are
up-to-date. And it would be quite useful to have an example code so that
I can compare my and working codes.
I am using Twog1.
Thank you.
Regards,
Roman
Bristol Institute of Technology
University of the West of England
Aerospace Systems Engineering
email: address@hidden<mailto:address@hidden>
Mob.: +44 (0) 7760806643
*P** **please consider the environment before printing emails.** *
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel