[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] PPM wiring

From: Simon Wilks
Subject: Re: [Paparazzi-devel] PPM wiring
Date: Sun, 10 Apr 2011 22:05:00 +0200

Have a look at this:

I connected the +, - and first signal wire to the throttle channel on the receiver (so the receiver has power). The remaining connections require the signal cable only, no need for +/-.


On Sun, Apr 10, 2011 at 8:02 PM, Roman Nikitin <address@hidden> wrote:

Hi all,


I did use ATmega168 PPM encoder before and it seems to be damaged now. So I ordered a newer one that is ATmega328. I am confused a bit, it is not clear how to wire it?! Three wires (+,-, signal) goes to the ap board, for another wires there is one +, one - , and 8 holes for the signals. I found this picture  and I am not sure now, how should I do a wiring. In 168 version each of the channels had power, ground and signal  which are going to R/C receiver. Does it mean here that the R/C receiver will be powered just from one wire with one ground wire?! , and for other channels signal wires must be connected only?!


Please, I need some help with it. I  have not found any instructions how to do it.


It would be nice to have a better picture with some instructions to it.  Just sent it to my private e-mail if you have some or may be a link.

Thank you.




Bristol Institute of Technology

University of the West of England

Aerospace Systems Engineering

e-mail: address@hidden

tel. +44 (0) 7760806643


 Please consider the environment before printing this email.



Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]