Re: [Paparazzi-devel] need help for motor controller with booz

[Eric BAHIER]

Hello,

I have in test a brushless motor controller I2C and/or PPM input.
It will accept 12 lipos, and 80Amps.

Aviabillity, after full test end of the summer.

Best regards,

Eric

Le 13/07/2011 07:24, Dong Zhao a écrit :

Hi, 

 

I brought a booz main board for a five rotor UAV. and things follow:

 

Motor:  Brushless Outrunner Motor 245Kv power160, continuous current 60A and max brust curent 78A.

Speed controller: PHOENIX ICE HV 80 brushless speed controller with max volts=50V and max amps=80A.

 

 

The problem at this moment is booz only accept I2C signal from speed controller, but i can't find a I2C controller for this 80A motor. 

Is this controller available? Where can i buy this speed controller?

 

OR,

 

If use both motor and speed controller above, how can i convert the PWM from speed controller to I2C signal? 

 

 

OR,

 

If I buy a Lisa/L board instead of the booz board and connect the five controllers to the servos section on the Lisa\L board,  is this a solution for this problem?

If I use this way, how to program?    

 

Regards

Dong

 

 

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

-- 
************************************
Lez Concept EURL

Eric BAHIER
15 chemin neuf
34 980 Montferrier sur LEZ
France

Tel : 33 4 67 59 92 53
Fax : 33 9 59 15 92 53
************************************