paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] error messages


From: Monika.Scheibe
Subject: Re: [Paparazzi-devel] error messages
Date: Wed, 3 Aug 2011 05:33:28 +0000

I got it.
As it worked without any error via direct connection with FTDI-cable I assumed 
something with XBee, again...
And when reading the preferences of the ground module, it had all forgotten. 
So, reprogramming the XBee-module and the error messages were gone :-).

My final question about this is what causes a module to forget its preferences?

Best wishes, Monika


> -----Urspr√ľngliche Nachricht-----
> Von: address@hidden
> [mailto:address@hidden Im
> Auftrag von Oliver Riesener
> Gesendet: 02 August 2011 21:45
> An: address@hidden
> Betreff: Re: [Paparazzi-devel] error messages
> 
> Hi Monika,
> 
> clean, build and flash your autopilot code.
> 
> Best wishes!
> 
> Oliver
> 
> Am 02.08.2011 09:07, schrieb address@hidden:
> > Dear community,
> >
> > since a few days (after I made a Paparazzi update with "git pull" and
> new paparazzi compilation "make") I get error messages during execution
> like:
> >
> > Failure("Pprz.values_of_payload, wrong argument: 00 08 ")
> > Failure("Pprz.values_of_payload, too many bytes: 00 03 01 2a 00 00 00 00
> 00 00 00 00 00 00 00 00 ")
> >
> > Even a new update and a new compilation did not help in this issue.
> >
> > Does anybody has the same problems? Or is anybody familiar with this
> message?
> >
> > Best wishes,
> > Monika
> > _______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
> 
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



reply via email to

[Prev in Thread] Current Thread [Next in Thread]