When the Tiny V2.11 powers up, a LED glows. This LED used to glow when we connected a standard 9V battery. However the LED no longer glows. On checking with the multimeter, I found that the board is getting a voltage in the range of 4.8V to 5.2 V. Is this sufficient to power up the LED? Or is it a problem with the board or should I change the battery(use one with higher voltage rating) and try again? We are a Paparazzi newbie team. Any help would be greatly appreciated
--
With warm regards,
B S Prateek
R.V. College Of Engineering
Bangalore