paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] PPM input Port


From: Jochen Rieger
Subject: Re: [Paparazzi-devel] PPM input Port
Date: Tue, 8 Nov 2011 15:59:53 +0100

Now, I am confused. In the wiki is written that the primary receiver input port is UART3.

Why is the Trig. Pin the input pin for PPM? I thought PPM -> Rx pin.



I want changed it because I thought UART3=PPM, but i have GPS on UART3.

Thanks for helping.
-Jochen



2011/11/8 Felix Ruess <address@hidden>
Hi Jochen,

If you want to use a PPM  receiver on Lisa, you currently can't change
the input pin for the ppm sum signal input.
It is hardcoded to UART1 trig (PA.01) pin.

Why do you need to change that?

Cheers, Felix

On Tue, Nov 8, 2011 at 2:39 PM, Jochen Rieger <address@hidden> wrote:
> Hello,
>
> I have a Lisa/L 1.1 board. I want to change the PPM input UART port. What
> must I edit at the airframe file?
>
> <subsystem name="radio_control" type="ppm">
>
> <configure name"RADIO_PORT"  value="UART2"/>
>
> </subsystem>
>
>
> Is that right? I could find nothing about this, neither in wiki nor in
> mailing list.
>
> Best regards.
> Jochen
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel


reply via email to

[Prev in Thread] Current Thread [Next in Thread]