[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Lisa M wiring layout

From: Eric Parsonage
Subject: Re: [Paparazzi-devel] Lisa M wiring layout
Date: Sun, 1 Jan 2012 01:46:19 +1030

Hi Bruzzlee

It looks good to me and yes the ADC1 bridge is needed only for the initial bind 
to the Spektrum receiver (or receivers, you can use two at once)

On 30/12/2011, at 7:51 AM, Bruzzlee wrote:

> Hi all
> After a long break I've continued the work on my quadrotor Lisa M project. 
> Now I've done my wiring layout but I'm not sure if everything is correct.
> Especially the power source for the board: I2C1 CAN (V_BATT/GND) or SERVO1 
> (SV/GND)?
> The ADC1 bridge - I need it only for the first binding to the spectrum remote 
>  - right?
> I want to publish this layout on wiki - please report mistakes!
> thx
> Bruzzlee
> <LisaMWiring.png>_______________________________________________
> Paparazzi-devel mailing list
> address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]