Hi Gareth,
When lisa/M connect with laptop use usb, the leds on board cycling up and
down. The dmesg command returned lots of message, i'm new to linux, i
don't
understand what these messages mean, the last few lines is:
[ 28.094007] wlan0: no IPv6 routers present
[ 99.302560] usb 2-1.1: new full speed USB device number 3 using
ehci_hcd
[ 99.951902] usb 2-1.1: USB disconnect, device number 3
[ 100.148796] usb 2-1.1: new full speed USB device number 4 using
ehci_hcd
[ 200.606504] usb 2-1.1: USB disconnect, device number 4
[ 216.299849] usb 2-1.1: new full speed USB device number 5 using
ehci_hcd
[ 299.590822] [Hardware Error]: Machine check events logged
[ 1466.043758] usb 2-1.1: USB disconnect, device number 5
[ 1480.050247] usb 2-1.1: new full speed USB device number 6 using
ehci_hcd
[ 2392.815210] usb 2-1.1: USB disconnect, device number 6
[ 2393.076340] usb 2-1.1: new full speed USB device number 7 using
ehci_hcd
[ 2640.364122] usb 2-1.1: USB disconnect, device number 7
[ 2663.910504] usb 2-1.1: new full speed USB device number 8 using
ehci_hcd
[ 2672.906905] usb 2-1.1: USB disconnect, device number 8
[ 2994.456797] usb 2-1.1: new full speed USB device number 9 using
ehci_hcd
thnaks,
Hi Chen,
Try the dmesg command just after plugging in your lisa/m and see what
is registered.
Does your Lisa/M have the leds all cycling up and down?
Cheers,
Gareth
Hi Tilman:
does "restarted udev" means reboot laptop or there is specific command of
linux i should set?
thanks,
On Wed, 02 May 2012 10:01:34 +0100, Tilman Baumann <address@hidden>
wrote:
On 02/05/12 08:13, C. Y. Chen wrote:
Thanks for reply,
I downloaded all the files under dev branch, make these files and copy
50-paparazzi.rules
to ./etc/udev/rules.d/ again, then tried upload firmware again, but get
another error:"no USB device". When i use another USB cable, i got the
same error too. how can i do to fix it?
I can only guess that you may have not restarted udev.