Re: [Paparazzi-devel] airframe configuration?

[hu zhangli]

GUI could list the stablization mode and related paras.

On Fri, Sep 28, 2012 at 5:04 PM, hu zhangli <address@hidden> wrote:
> but we should know about the acutal val ,then fill in the xml.
>
> firstly how to get the RC val , maybe GUI is good sensitive to teach
> user . for example the GUI could show the RC throlle, yaw. range when
> RC is operated by user.
>
> Openpilot support such feature.
>
>
> On Fri, Sep 28, 2012 at 5:00 PM, Christophe De Wagter
> <address@hidden> wrote:
>> http://paparazzi.enac.fr/wiki/Paparazzi_Center
>>
>> the radio file defines the ppm signals of your receiver.
>>
>> the airframe file defines the servo deflections
>>
>> -Christophe
>>
>>
>>
>>
>> On Fri, Sep 28, 2012 at 10:52 AM, hu zhangli <address@hidden> wrote:
>>>
>>> for example if we choose ppm, how to config the related channels and
>>> threshhold value setting max ...min...
>>>
>>> On Fri, Sep 28, 2012 at 4:09 PM, Christophe De Wagter
>>> <address@hidden> wrote:
>>> > Unfortunately that guide is quite outdated. Several things still apply
>>> > but
>>> > not the makefile part.
>>> >
>>> > There is no more need for Makfile in your airframe. You can configure
>>> > the
>>> > autpilot using firmware, board and subsystems blocks.
>>> >
>>> > Look at: http://paparazzi.enac.fr/wiki/Airframe_Configuration
>>> >
>>> > and in ./conf/airframes/examples for something that matches your
>>> > hardware
>>> >
>>> > -Christophe
>>> >
>>> >
>>> >
>>> > On Thu, Sep 27, 2012 at 2:06 PM, iman shirdareh
>>> > <address@hidden>
>>> > wrote:
>>> >>
>>> >> Hi
>>> >>
>>> >> I have some problem with airframe configuration, I'm following this
>>> >> guid:http://www.rcgroups.com/forums/showthread.php?t=1000937
>>> >>
>>> >> but I can't find funjet1.XML file and there isn't any
>>> >>
>>> >>  <makefile>
>>> >> CONFIG = \"tiny_2_1.h\"
>>> >>
>>> >>
>>> >> in other example file, to change that?!
>>> >>
>>> >> I want to use my autopilot with Cessna 182 , Is there any similar
>>> >> airframe
>>> >> file to use?
>>> >>
>>> >>
>>> >>
>>> >> Thanks a lot..........Iman
>>> >>
>>> >>
>>> >> _______________________________________________
>>> >> Paparazzi-devel mailing list
>>> >> address@hidden
>>> >> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>>> >>
>>> >
>>> >
>>> > _______________________________________________
>>> > Paparazzi-devel mailing list
>>> > address@hidden
>>> > https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>>> >
>>>
>>> _______________________________________________
>>> Paparazzi-devel mailing list
>>> address@hidden
>>> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>>
>>
>>
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden
>> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>>