|
From: | Cedric Marzer |
Subject: | [Paparazzi-devel] lisa m and ppm input |
Date: | Wed, 3 Oct 2012 22:26:40 +0200 |
Hello, I am trying to connect a ppm receiver to a lisa m V2 board. I'd need all 8 servo outputs. Apparently the ppm input is supposed to be connected to the servo No 6 output. Is there an alternative way to connect it to the uart 1 rx pin ? I am not familiar with the STM32 so I am not sure how difficult it would be to adapt the code (and if it is possible at all). Any help appreciated. Cedric
[Prev in Thread] | Current Thread | [Next in Thread] |