paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Quadrotor with Lia 1.1 - a sudden loss control aut


From: Eduardo lavratti
Subject: Re: [Paparazzi-devel] Quadrotor with Lia 1.1 - a sudden loss control authority after switching from Z_HOLD to ATT
Date: Fri, 23 Nov 2012 21:38:52 +0000

I do more 6 flights
4 flight only in HOVER and another 2 in ALT_Z_HOLD.

for 2 times the rotorcraft sudden loss altitude and stay in the ground when i use alt_z_hold.
This time i am using adaptive guidance v


From: address@hidden
To: address@hidden
Date: Fri, 23 Nov 2012 19:44:49 +0000
Subject: Re: [Paparazzi-devel] Quadrotor with Lia 1.1 - a sudden loss control authority after switching from Z_HOLD to ATT

Tks felix
i am using v4.0.3_stable-4-gb380a3c-dirty



Date: Fri, 23 Nov 2012 20:42:35 +0100
From: address@hidden
To: address@hidden
Subject: Re: [Paparazzi-devel] Quadrotor with Lia 1.1 - a sudden loss control authority after switching from Z_HOLD to ATT

Run ./paparazzi_version from your paparazzi dir...


On Fri, Nov 23, 2012 at 8:39 PM, Eduardo lavratti <address@hidden> wrote:
How i do to get the code version ?
i not shure but i use git branch -vv
Result: V4.0  b380a3c


From: address@hidden
To: address@hidden
Date: Fri, 23 Nov 2012 19:14:39 +0000
Subject: Re: [Paparazzi-devel] Quadrotor with Lia 1.1 - a sudden loss control authority after switching from Z_HOLD to ATT


Michal, today i am flying using Z_HOLD and after some minutes the rotorcraft rapidly descent and touch the ground (while staying table).
The baterry is full charged ... no radio glitch.

I land the rotorcraft and start another flight.
This time the Z_HOLD stay working for more 6 minutes without problem.

i am using default guidance_v loop.

I do more flight´s and post the result here.



Date: Thu, 8 Nov 2012 14:58:45 -0700
From: address@hidden
To: address@hidden
Subject: [Paparazzi-devel] Quadrotor with Lia 1.1 - a sudden loss control authority after switching from Z_HOLD to ATT

Hi everybody,

we are testing a quadrotor with Lia 1.1. board and Paparazzi code v.4.0.3, using the adaptive throttle estimation for hover (as is in guidance_v_adpt.h)

During a flight everything went great until the RC pilot switched from AP_MODE_ATTITUDE_Z_HOLD (Z_HOLD with a barometer) to AP_MODE_ATTITUDE_DIRECT (ATT). At that moment we experienced a sudden loss of control authority over the quad (there was only a limited amount of authority, as is the NAV mode) and the craft started to rapidly descend (while staying stable). The full control was restored after roughly 15 seconds (where it was already just above the ground).

From the logs can be seen that the problem wasn't radio connection, and the AP mode was correctly switched to ATT. IMU, GPS, and barometer were also working normally. However thrust command from RC pilot seemed to be overridden by adaptive estimator, even though we were in ATT mode. A possible explanation would be a software glitch during switching the AP modes.

Have you ever came across a similar issue (i.e. autopilot software glitch)?

Regards
Michal





_______________________________________________ Paparazzi-devel mailing list address@hidden https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________ Paparazzi-devel mailing list address@hidden https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



_______________________________________________ Paparazzi-devel mailing list address@hidden https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________ Paparazzi-devel mailing list address@hidden https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

reply via email to

[Prev in Thread] Current Thread [Next in Thread]