paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Lisa_m 1.0 PPM on UART Connector


From: Stephen Dwyer
Subject: Re: [Paparazzi-devel] Lisa_m 1.0 PPM on UART Connector
Date: Sat, 19 Jan 2013 19:58:56 -0700

Hello,

No, uart3 rx has no timer channel associated with it unfortunately. If you do end up needing the uart3 tx, it is available on PC10 on the GPIO connector though, say for using the ucenter module. Shouldn't be too hard to configure.

Thanks,
-Stephen


On Sat, Jan 19, 2013 at 7:40 PM, Eduardo lavratti <address@hidden> wrote:
Hello Stephen,
I put PPM receiver connected direct on UART1 and GPS on spektrum receiver connector and its working fine.

I  think the lisa_m cannot work with ppm input on uart3 rx right ?

for the moment i not using gimbal but in the future i will use ... so i need more 3 servo connector.
i will use servo7 and 8 and modify the pwm_actuator to use more 2 outputs as servos.

thanks for attention.



Date: Sat, 19 Jan 2013 19:27:50 -0700
From: address@hidden
To: address@hidden
Subject: Re: [Paparazzi-devel] Lisa_m 1.0 PPM on UART Connector


Hey Eduardo,

Did you figure it out (do you have enough servo outputs while still using ppm input on the servo6 connector?). If not, how many servo outputs do you need and what other components do you have attached to your system?

Thanks,
-Stephen Dwyer


On Sat, Jan 19, 2013 at 7:20 PM, Eduardo lavratti <address@hidden> wrote:
OPsss REMAP servos is not necessary.

AGRESSiVA HiGH PERFORMANCE /// (o o) ____ooO__(_)__Ooo____ By Dudu


From: address@hidden
To: address@hidden
Date: Sat, 19 Jan 2013 23:08:28 -0200
Subject: [Paparazzi-devel] Lisa_m 1.0 PPM on UART Connector


Hello, today i am configuring the lisa_m 1.0 to use in the hexacopter frame.
The first problem is the servos conector.
To use servo5 and 6 i need to configure "REMAP_SERVOS_ 5AND6"
this config not work is you are using PPM on servo6 conector.

The second problem is the PPM input when configured to use UART conector.
On lisa_m 1.0 the conector use UART3 and 5 and on lisa_m 2.0 the uart is 1 and 5.


_______________________________________________ Paparazzi-devel mailing list address@hidden https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



_______________________________________________ Paparazzi-devel mailing list address@hidden https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



reply via email to

[Prev in Thread] Current Thread [Next in Thread]