[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Paparazzi-devel] funjet-Sumo
From: |
Árni Þorvaldsson |
Subject: |
[Paparazzi-devel] funjet-Sumo |
Date: |
Mon, 24 Jun 2013 11:46:07 +0000 |
Hi I was reading over the sumo instruction on the wiki and noticed this in the
xbee section:
"Remove R5, R6, R7, R8, Q1, and Q2 from the XBee explorer regulated breakout
board. Bridge OUT-DOUT and IN-DIN within the transistor. Solder the cables to
the XBee explorer board, plug cables in 5-pin Molex connector."
Can anyone tell me why this is done?
Kind regards Arni Th
- [Paparazzi-devel] funjet-Sumo,
Árni Þorvaldsson <=