Re: [Paparazzi-devel] simple question for rotorcraft

[evan igor]

Hi Stephen;

i appreciate your answer i asked this question to know exactly the relationship between the mechanical design and the firmware where to change i read much about paparazzi and configuration for rc, speed controller, motors and telemetry . but nothing talk about m.design and i think if there is reference for i hope you refer to.

thanks

On Fri, Aug 2, 2013 at 9:23 PM, Stephen Dwyer <address@hidden> wrote:

Hello,

That is not really a simple yes or no question. The simple answer is no... because it depends very heavily on the mechanical design of your quadcopter, assuming you have compatible speed controls, and all your sensors/gps/radios/rc etc is set up correctly and working. If you happen to have similar motors, props, all up weight, batteries and mechanical structure of your quad as to the quad for which that firmware was designed, then there is a chance it would just fly. There is a chance it will be able to fly regardless, even without a similar mechanical design, but it might be very very poor performance without any tuning...

Thanks,

-Stephen Dwyer

On Fri, Aug 2, 2013 at 12:25 PM, evan igor <address@hidden> wrote:

Hi all, 

 i have simple question for CGS if i upload the firmware for quadrotor_lisa_m_2_pwm_spektrum

and upload it with its settings ,telemetry and guidance with no changes will and fit the board to the quadcopter will it be able to fly or not.

thanks for all.

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel