Re: [Paparazzi-devel] help

[Junnan Shen]

yes the spektrum receiver have bind with my dx6i the light showed on red. but the led in lisa didn't blink and i can't control it.is there any unlock swich  just like apm?

在 2013年8月14日 上午9:14，"Freek van Tienen" <address@hidden>写道：

Because all spektrum receivers have the same channel order there is no need to configure a radio.xml

Does the light on the spektrum receiver itself blink? And did you bind your transmitter with the receiver, by plugging in the bind plug on the Lisa M and then starting the DX6i in bind mode?

The light on the Lisa M goes on when it starts receiving RC packets from the transmitter, so as long as that one isn't on you can't control your plane.

2013/8/14 Junnan Shen <address@hidden>

Dwyer
    thank you very much!
    For now,I have put my Dsm2 in uart5 and config the xml.but led 4 don't blink.and i can't control my quadshot.For dx6i i have set up a three-switch.and a   right pwm.
    so i wish that if you have the xml which dx6i could use for a quadshot can canyou sent to me.
     thanks again!
       Shen Junnan

在 2013年8月14日 上午3:02，"Stephen Dwyer" <address@hidden>写道：

Hello,

What exactly doesn't work? More details are needed to figure out exactly what is wrong.

If you have the spektrum subsystem loaded in the firmware section of the airframe file, it should be working, assuming you bind the satellite to the transmitter.

See here for R/C subsystem details:
http://paparazzi.enac.fr/wiki/Subsystem/radio_control#Spektrum

Note that the spektrum subsystem does NOT use a radio control xml file (but you still need one in the conf.xml, you can use spektrum.xml or dummy.xml or something).

If you want to set up two two-way switches to get three modes (i.e. one switch manual/auto, the other auto1/auto2 depending on the state of the first switch), that is certainly possible, like bullet 1 here:

http://wiki.thequadshot.com/wiki/RC_Radios_and_Receivers

Hopefully that helps.

Thanks,

-Stephen Dwyer

On Tue, Aug 13, 2013 at 7:34 AM, Junnan Shen <address@hidden> wrote:

My ppz lisam2.0,cann't use dx6i...
who can send me a airfram.xml and radio.xml to see.

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel