Re: [Paparazzi-devel] connect gps ublox 6

[evan igor]

did you try to connect 6s lipo battery to paparazzi

On Wed, Jan 8, 2014 at 2:07 PM, Marius Pfeffer <address@hidden> wrote:

I have a NEO6M and it has only a resistor in the rx and the tx line. I'm using it with 5V. Look at the wiki(currently not available), jp6 close jp7 open will connect v_in to the gps

Marius

Am 08.01.2014 13:03 schrieb "evan igor" <address@hidden>:

Hi,

thanks Marius but in the datasheet of the ublox its max input voltage 3.3v so if you tried to work with 5v it'll be great but i'm afraid to loose the GPS  and what do you think if i made the change of status for j6 &j7 switch close and open case to be in the safe side.

thanks

On Wed, Jan 8, 2014 at 1:05 PM, Marius Pfeffer <address@hidden> wrote:

Hello

Use a external 5V regulator on v_in pin. Close JP3.

JP6 closed JP7 open -> gps connected to v_in rail.

Most ublox boards have a on board 3v3 regulator.

Hobbyking's neo6m 14€ module can work with 5v.

cheers
Marius

Am 08.01.2014 10:50 schrieb "evan igor" <address@hidden>:

Hi everyone;

i'm trying to connect gps ublox that powered by 3.3v

should i close th jumper j7 and open the jumper j6.

or what should i do?

thanks

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel