Re: [Paparazzi-devel] i2c silent again

[David Conger]

Hello,

I do not know. Sounds  like possible damage to the LPC with your
modifications. Again, another question best asked to the developers
who designed NavGoV3.

Best,
David

On Tue, Feb 11, 2014 at 8:24 AM, SilaS <address@hidden> wrote:
> Hi David,
>
> I am again in trouble. I want to replace my powering from 3S to 4S because
> my neutral-hower-throttle was around 80% of throttle.
>
> For to do it: I removed the power from main power distribution board and
> made a connector for balancer port of the same battery as feed the power
> board. On balancer I connected only the first 3 cell and therefore I hope
> that can watch the consumption while i got my atto sensor.
> I powered first the AP over balancer and a few minutes later the main
> connectors. The AP started perfect, the I2C ESC-s - what I got also from You
> - started as regular, but at the end all show red LED on, so indocate no
> signal on I2C0 bus!!!!
> So I can not start the motors!!!!
>
> A few minutes later I made everything back to 3S config. But the problem is
> the same! What can happen? How can I check the I2C communiction of AP?
>
> SilaS
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel



-- 
address@hidden
http://www.ppzuav.com