Re: [Paparazzi-devel] Copter tuning/setup cookbook step-by-step

[SilaS]

Hi Boys,

I was a bit busy with building of a few airplanes, but I am back:

I achieved this:
1. Replaced the NavGo with Sergey's KroozSD BRE edition.
2. Replaced two burned mk esc.
3. Replacement of battery tray, now it is above the center circuits.
4. Installed and setup a Sparkfun 90A amper measurement circuit.

Finished with:
- ACCEL calibration
- MAG calibration
- AHRS normalization to Budapest
- Actuators addressing and motor_mixing - I use X hexa setup

Till not finished:
- MAG_CURRENT_CALIBRATION:
 I now have amperage, but can not do IMU_MAG_CURRENT_CALIBRATION messages
out form logs! I do not understand why? So therefor I use my previous
measurement fro NavGo on the same frame. Currently see 15-20 diff at 80% of
throttle on all axes of MAG
- I use Sergey-s example PIDs, but can not be sure, that it is correct,
because last time in my TESTING ENVIRONMENT (two hook on garage door - the
motors overrun and kill 2 of escs. So I hesitate to repeat it!

and may last problem is, that SERGEY seems to DISAPPEARED!

Attached photos of buildup 
https://plus.google.com/photos/109706023057893946563/albums/6003154888193406193?banner=pwa
<https://plus.google.com/photos/109706023057893946563/albums/6003154888193406193?banner=pwa>
  

Current config  tarot.xml
<http://lists.paparazziuav.org/file/n15312/tarot.xml>  

SilaS



--
View this message in context: 
http://lists.paparazziuav.org/Copter-tuning-setup-cookbook-step-by-step-tp14386p15312.html
Sent from the paparazzi-devel mailing list archive at Nabble.com.