[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Paparazzi-devel] [TWOG] CAM Port Pins

From: Kristofer Von Ahnen
Subject: [Paparazzi-devel] [TWOG] CAM Port Pins
Date: Mon, 01 Dec 2014 18:03:53 -0600
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:31.0) Gecko/20100101 Thunderbird/31.0

Is it possible to regulate the voltage of the CamSW pin on the TWOG board ( for sending a hardware signal to a separate device? I notice in the cam_control module that the servo pins are being used to adjust a camera's position by sending commands, but can the same be done with the CamSW pin?


reply via email to

[Prev in Thread] Current Thread [Next in Thread]