[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Replace Voltage Regulator on Lisa/m.v2

From: Zorig Bat
Subject: Re: [Paparazzi-devel] Replace Voltage Regulator on Lisa/m.v2
Date: Thu, 16 Jul 2015 11:36:53 -0500

Oops, I meant the component layout diagram which is not published on the wiki.

Also do you know where I can purchase a replacement voltage regulator for my Lisa/M V2


On Thu, Jul 16, 2015 at 3:48 AM, Felix Ruess <address@hidden> wrote:
For schematics see

On Wed, Jul 15, 2015 at 11:31 PM, zorigb <address@hidden> wrote:
I was testing my Lisa/M.V2 board and I accidentally burned it. I was using my
ESC to power the board through one of the servo pins.Everything was fine
until I smelt something burning and the board stopped working even though
the life led(green) is still on. I was shorting the GND and ADC1 pins on the
analog1 port in order to bind a spektrum receiver. I don't exactly know what
went wrong. Afterwards I checked the resistors on the board and some
resistors we're not working anymore. I think the voltage regulator was
damaged somehow and am looking for a way to replace it. Does anyone have
experience replacing the voltage regulator? Also if you have a schematic of
the board can you share it, it would be greatly helpful.

Thank you

View this message in context:
Sent from the paparazzi-devel mailing list archive at

Paparazzi-devel mailing list

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]