[Paparazzi-devel] Apogee RC not Working Properly

[Pengzhi Tian]

Hello everyone,

I am currently working on an Apogee board, however I couldn't get RC working
properly. I am using a Spektrum DX7s transmitter. As you might already know,
Apogee can take both ppm signal or Spektrum directly. I tried both, however,
none of these seem to work properly. The problem with ppm signal in is that
servos response really slow. With Spektrum directly in, servos could work
normally sometimes, but it's on and off, doesn't seem to be consistent. I
already checked all connections and tested on two brand new Apogee boards.
Looks like this problem is always there. Can anyone tell me where the
problem comes from or any suggestions? 

Another question, when connect Specktrum receiver directly to Apogee board
through R/C RX2, what is the correct way to bind the transmitter? I noticed
on the paparazzi wiki it says on Apogee board AUX4 is also spektrum bind
pin. Is it similar with Lisa board that I should connect AUX4 to GND?

Thanks!

Pengzhi



--
View this message in context: 
http://lists.paparazziuav.org/Apogee-RC-not-Working-Properly-tp17742.html
Sent from the paparazzi-devel mailing list archive at Nabble.com.